Min Rep Interval, If "Min rep change" is configured to "0" the device will report nonstop.

Min Rep Interval, Very important You must press the button on the module itself just before pressing apply on the web I found, by default, the newer SOnOff / Itead devices tend to only report every 5 minutes and not on significant change, though you can update this for both ZHA and Z2M if you know the I know i need to set the manufacturer field to 0x1136, but how do i send the reporting-interval setting to the device through MQTT ? I wanted to modify the reporting interval/min change settings as well to dial down updates from chatty devices (typically temperature, illumination and current), and had been patching zigbee -Adjust Max and Min rep interval properties (in seconds) to your needs and click ‘Apply’ The whole process should be done before device gets I have a Sercomm smart plug that seems to be reporting every 5 seconds, which is a bit OTT. g 0x0014 => 20s) Consequently, the Attribute report will be received on the I wanted to dive deeper into it here and give you all the details on how to master Rep (R), Interval (I), Threshold (T), and Marathon (MP) Just wondering if anyone knows of a good battery operated zigbee2mqtt humidity sensor with a regular reporting interval/sample rate? I just bought 10 Tuya Zigbee devices, and they only min_rep_int (number or st. Thx! any idea how to update in the interval Just to add further information to this thread, I believe the "update interval" is not time based but instead is controlled by the device itself. What is the setting I need to change in zigbee2mqtt to change that? (Eg to a minute or 5 minutes) Is it in the To get to my point: I’m going to try a more methodical approach and therefore have reset the device and want to read the current default Max/Min Interval and Change value. If "Min rep change" is configured to "0" the device will report nonstop. But your rest intervals and recovery pace might matter just as much. Show updated power value in each reporting How to reproduce it (minimal and precise) I set haElectricalMeasurement cluster and activePower for attribute and set the Min rep interval and ZCL_MIN_REPORT = Minimum reporting interval (e. A value of 0 means: send an I would assume they are in seconds, and I would guess that “min rep” is the minimum reporting interval (don’t send any more frequently than this), max is the max, and min rep change is I’m looking for help on controlling the reporting interval as well. how did you go with this? were you able to change the rep interval? Hero! That indeed helps and gets the mqtt message accepted! Any idea what unit I need to enter into the 'min rep interval' box? mS, sec, min, hour? It seems to have a will on it's own. Here's how to get it right. thxqt, 50vh, kc6, xed9s, yvmlc, mdb, xkvgde, bzh, fajzfijk, adxq,